First we had an electrician wire a new power supply into a dedicated circuit. Then the heat matrix mat is installed and holds the heat cable that is wired to the thermostat. We then thinset over the mat. Once that is setup you can layout the tile and set the tile. This particular job used a wood look porcelain tile. This was a larger area that required a 240 Volt.
Once the job is done just a quick turn on of the thermostat and you have a warm tile floor.
If you would like more information on heated floors or would like to setup an appointment to find out how much it would cost to heat your particular space call our office @402-596-0320 or call Dan directly @ 402-510-5865.
